Ptp Delay-Req Interval - Cisco MWR 2941 Command Reference Manual

ptp delay-req interval

ptp delay-req interval
Specifies the delay request interval, the time recommended to member devices to send delay request
messages when an interface is in PTP master mode.
Syntax Description
interval
interval-value
Defaults This command is disabled by default.
Command Modes Interface configuration
Command History Release
12.4(20)MR
12.2(33)MRA
15.0(1)MR
Usage Guidelines
The recommended interval value is -6.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
336
ptp delay-req interval [interval-value]
no ptp delay-req interval [interval-value]
Specifies an interval for PTP delay requests.
Specifies the length of the interval for delay request messages. The intervals
are set using log base 2 values, as follows:
4—1 packet every 16 seconds
3—1 packet every 8 seconds
2—1 packet every 4 seconds
1—1 packet every 2 seconds
0—1 packet every second
-1—1 packet every 1/2 second, or 2 packets per second
-2—1 packet every 1/4 second, or 4 packets per second
-3—1 packet every 1/8 second, or 8 packets per second
-4—1 packet every 1/16 seconds, or 16 packets per second.
-5—1 packet every 1/32 seconds, or 32 packets per second.
-6—1 packet every 1/64 seconds, or 64 packets per second.
The recommended value is -6.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01