Level (Cfm-Ais-Link) - Cisco MWR 2941 Command Reference Manual

level (CFM-AIS-link)

level (CFM-AIS-link)
To configure a maintenance level to receive Alarm Indication Signal (AIS) frames transmitted by a
link-status change (server maintenance endpoint [SMEP]), use the level command in CFM SMEP AIS
configuration mode. To remove the maintenance level, use the no form of this command.
Syntax Description level-id
Command Default
A maintenance level is not configured.
Command Modes
CFM SMEP AIS configuration (config-ais-link-cfm)
Command History Release
12.2(33)SRD
15.0(1)XA
15.0(1)MR
Usage Guidelines This command allows you to transmit AIS messages to a higher level maintenance association without
configuring a maintenance intermediate point (MIP) for the service.
Examples
The following example shows how to configure maintenance level 5 as the level to receive AIS frames
transmitted by a link-status change:
Router(config)# ethernet cfm ais link-status global
Router(config-ais-link-cfm)# level 5
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
206
level level-id
no level
Integer from 0 to 7 that specifies the maintenance level.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 15.0(1)XA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01