Ptp Tod - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

ptp tod

Configures the time of day message format used by the 1PPS interface.
Syntax Description iso8601
ubx
nmea
cisco
ntp
delay-amount
Defaults
The default configuration is ptp tod iso8601.
Command Modes Global configuration
Command History Release
12.4(20)MR
12.2(33)MRA
15.0(1)MR
Usage Guidelines
This command applies only to the Cisco MWR 2941-DC-A; it does not apply to the Cisco MWR
2941-DC.
Examples
The following example shows how to configure a PTP announcement interval.
Router# config t
Router(config)# ptp tod ubx 100
Router(config)# exit
Router#
Related Commands Command
ptp enable
ptp mode
ptp 1pps enable
OL-23890-01
ptp tod {iso8601 | ubx | nmea | cisco | ntp} delay-amount
no ptp tod {iso8601 | ubx | nmea | cisco | ntp} delay-amount
Specifies ISO 8601 time of day format.
Specifies UBX time of day format.
Specifies NMEA time of day format.
Specifies Cisco time of day format.
Specifies NTP time of day format.
Specifies the delay in milliseconds between the 1PPS message and the time of
day message. Valid values are 1–999.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Description
Enables PTP mode on an interface.
Specifies the PTP mode.
Configures the router to send or receive 1PPS time of day messages.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ptp tod
355