Preferred-Path - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

preferred-path

Specifies the preferred path within an MPLS pseudowire-class where multiple paths exist. To remove a
preferred path, use the no form of this command.
Syntax Description
interface
tunnel
tunnel
peer
peer
disable-fallback
Command Default
This command is disabled by default.
Command Modes Pseudowire class configuration
Command History Release
12.0(25)S
12.2(25)S
12.2(28)SB
12.2(33)SRA
12.4(20)MR
12.2(33)MRA
15.0(1)MR
Examples
The following example creates a pseudowire class called pw_tun2, specifies MPLS encapsulation, and
specifies a preferred path with fallback disabled.
Router# configure terminal
Router(config)# pseudowire-class pw_tun2
Router(config-pw-class)# encapsulation mpls
Router(config-pw-class)# preferred-path peer 50.0.0.2 disable-fallback
OL-23890-01
preferred-path {[interface] tunnel tunnel] | peer peer} disable-fallback
no preferred-path {[interface] tunnel tunnel] | peer peer} disable-fallback
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.2(25)S.
This command was integrated into Cisco IOS Release 12.2(28)SB.
This command was integrated into Cisco IOS Release 12.2(33)SRA.
This command was integrated into Cisco IOS Release 12.4(20)MR.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Specifies the preferred path using an output interface.
Specifies a tunnel interface.
The tunnel interface number.
Specifies the preferred path using a peer host name or IP address.
The peer host name or IP address.
Specifies that pseudowire class traffic cannot use an alternate route.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
preferred-path
319