Rep Segment - Cisco MWR 2941 Command Reference Manual

rep segment

rep segment
Use the rep segment interface configuration command to enable Resilient Ethernet Protocol (REP) on
the interface and to assign a segment ID to it. Use the no form of this command to disable REP on the
interface.
Syntax Description segment-id
edge
no-neighbor
primary
preferred
Defaults
REP is disabled on the interface.
When REP is enabled on an interface, the default is for the port to be a regular segment port.
Command Modes
Interface configuration
Command History Release
12.2(40)SE
12.2(33)SRC
Cisco IOS XE Release
2.2
12.2(33)MRA
15.0(1)MR
Usage Guidelines
REP ports must be Layer 2 trunk ports.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
374
rep segment segment-id [edge [no-neighbor][primary]] [preferred]
no rep segment
Assign a segment ID to the interface. The range is from 1 to 1024.
(Optional) Identify the interface as one of the two REP edge ports. Entering the edge
keyword without the primary keyword configures the port as the secondary edge
port.
Specifies that the MWR 2941 interface does not have a REP neighbor because it is
connected to a switch that does not support REP.
(Optional) On an edge port, specify that the port is the primary edge port. A segment
has only one primary edge port. If you configure two ports in a segment as the
primary edge port, for example ports on different switches, the REP selects one of
them to serve as the segment primary edge port.
(Optional) Specify that the port is the preferred alternate port or the preferred port
for VLAN load balancing.
Configuring a port as preferred does not guarantee that it becomes the
Note
alternate port; it merely gives it a slight edge among equal contenders. The
alternate port is usually a previously failed port.
Modification
This command was introduced.
This command was implemented on the Cisco 7600 series router.
This command was implemented on the Cisco ASR 1000 Series Aggregation
Services Router.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
Release 15.0(1)MR does not support the no-neighbor keyword.
Support for the no-neighbor keyword was introduced.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01