Ptp Input - Cisco MWR 2941 Command Reference Manual

ptp input

ptp input
Enables PTP input clocking using the 1.544Mhz, 2.048Mhz, or 10Mhz timing interface or time of day
messages using the 1PPS interface.
Syntax Description
10M
2.048M
1.544M
1pps
Defaults
This command is disabled by default.
Command Modes
Global configuration
Command History Release
12.4(20)MR
12.2(33)MRA
15.0(1)MR
Usage Guidelines
If you are using GPS to provide clock source to the router, configure this command in PTP master mode.
Examples
The following examples show how to configure PTP input clocking:
Router# config t
Router(config)# ptp input 10M
Router(config)# network-clock-select 5 10M
Router(config)# exit
Router# config t
Router(config)# ptp input 1pps
Router(config)# exit
Related Commands Command
network-clock-select
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
342
ptp input {{{10M | 2.048M | 1.544M} [1pps]} | 1pps}
no ptp input {{{10M | 2.048M | 1.544M} [1pps]} | 1pps}
Specifies PTP input at 10 Mhz using the 10Mhz timing port.
Specifies PTP input at 2.048 Mhz using the 10Mhz timing port.
Specifies PTP input at 1.544 Mhz using the 10Mhz timing port.
Configures the router to receive 1 packet per second (1PPS) time of day
messages using the RS422 port or 1PPS port. You can select 1PPS with or
without selecting a timing port.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Description
Specifies a network clock timing source and priority.
OL-23890-01