Table of Contents
Advertisement
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Note
The set cos command is applied when you create a service policy in QoS policy-map configuration mode
and attach the service policy to an interface or ATM virtual circuit (VC). For information on attaching
a service policy, refer to the "Modular Quality of Service Command-Line Interface Overview" chapter
of the Cisco IOS Quality of Service Solutions Configuration Guide.
Related Commands
Command
match cos
policy-map
service-policy
set dscp
set precedence
show policy-map
show policy-map class Displays the configuration for the specified class of the specified policy
show policy-map
interface
OL-23890-01
Description
Matches a packet on the basis of Layer 2 CoS marking.
Creates or modifies a policy map that can be attached to one or more
interfaces to specify a service policy.
Attaches a policy map to an input interface or VC, or an output interface or
VC, to be used as the service policy for that interface or VC.
Marks a packet by setting the Layer 3 DSCP value in the ToS byte.
Sets the precedence value in the packet header.
Displays the configuration of all classes for a specified service policy map
or all classes for all existing policy maps.
map.
Displays the configuration of all classes configured for all service policies
on the specified interface or displays the classes for the service policy for a
specific PVC on the interface.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
set cos
407
Advertisement
Table of Contents
