Ptp Boundary - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

ptp boundary

To enable PTP boundary clock on an interface, use the ptp boundary command in interface
configuration mode. To remove a boundary clock configuration, use the no form of this command.
Syntax Description
multicast
unicast-
negotiation
Defaults
No default settings or behaviors.
Command Modes
Interface configuration
Command History Release
15.0(2)MR
Usage Guidelines You must configure the ptp mode boundary global command in order to use the ptp boundary
command.
This command is only supported on VLAN interfaces.
Examples
The following example shows how to configure an interface as a PTP boundary clock:
Router# config t
Router(config)# ptp mode boundary
Router(config)# ptp priority1 128
Router(config)# ptp priority2 128
Router(config)# ptp domain 1
Router(config)# interface vlan1
Router(config-if)# ip address 192.168.1.2 255.255.255.0
Router(config-if)# ptp announce interval 3
Router(config-if)# ptp announce timeout 2
Router(config-if)# ptp sync interval -4
Router(config-if)# ptp delay-req interval -4
Router(config-if)# ptp boundary multicast
Router(config-if)# ptp enable
OL-23890-01
ptp boundary [multicast | unicast-negotiation]
no ptp boundary [multicast | unicast-negotiation]
Configures the interface as a multicast boundary clock.
Configures the interface as a unicast boundary clock with negotiation enabled.
Modification
This command was introduced.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ptp boundary
331