Class Cem - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

class cem

To configure CEM interface parameters in a class that is applied to CEM interfaces together, use the
class cem command in global configuration mode. This command works in the same manner for CEM
interfaces as the pseudowire-class command does for xconnect.
Syntax Description
class-name
Command Modes Global configuration
Command History Release
12.4(12)MR2
12.2(33)MRA
15.0(1)MR
Usage Guidelines
The class cem command allows you to configure CEM interface parameters in a class that is applied to
CEM interfaces together. A class cem command includes the following configuration settings:
•
•
•
Note You can improve the performance of packet reordering on TDM/PWE connections by using the
increasing the size of the dejitter buffer using the dejitter-buffer parameter.
Examples
The following example shows how to configure CEM interface parameters:
Router# config t
Router(config)# class cem mycemclass
Router(config-cem-class)# dejitter-buffer 10
Router(config-cem-class)# sample-rate 32
Router(config-cem-class)# exit
Router(config)# interface cem 0/0
Router(config-if)# no ip address
Router(config-if)# cem 0
Router(config-if-cem)# xconnect 10.10.10.10 200 encapsulation mpls
Router(config-if-cem-xconn)# cem class mycemclass
Router(config-if-cem)# exit
Router(config-if)# exit
Router(config)# exit
OL-23890-01
class cem class-name
The name of a CEM interface parameters class.
Modification
This command was incorporated.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
dejitter-buffer dejitter-in-ms
idle-pattern 8-bit-idle-pattern
payload-size payload-size-in-ms
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
class cem
39