Name (Mst) - Cisco MWR 2941 Command Reference Manual

name (MST)

name (MST)
To set the name of a Multiple Spanning Tree (MST) region, use the name command in MST
configuration submode. To return to the default name, use the no form of this command.
Syntax Description
name
Defaults
Empty string
Command Modes
MST configuration (config-mst)
Command History Release
12.2(14)SX
12.2(17d)SXB
12.2(33)SRA
15.0(1)MR
Usage Guidelines
Two or more Cisco 7600 series routers with the same VLAN mapping and configuration version number
are considered to be in different MST regions if the region names are different.
Caution Be careful when using the name command to set the name of an MST region. If you make a mistake,
you can put the device in a different region. The configuration name is a case-sensitive parameter.
Examples
This example shows how to name a region:
Router(config-mst)# name Cisco
Router(config-mst)#
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
252
name name
no name name
Name to give the MST region. It can be any string with a maximum length of 32
characters.
Modification
Support for this command was introduced on the Supervisor Engine 720.
Support for this command on the Supervisor Engine 2 was extended to
Release 12.2(17d)SXB.
This command was integrated into Cisco IOS Release 12.2(33)SRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01