Network-Clock Output-Source - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

network-clock output-source

To transmit clocking to an external timing source using a timing output interface, use the network-clock
output-source command in configuration mode. To disable clocking output, use the no form of this
command.
Syntax Description
priority
interface
interface-name The name of the interface connected to the clock input.
slot
card
port
controller
t1
e1
slot
card
port
external
slot
card
port
t1
sf
esf
d4
e1
crc4
fas
cas
crc4
j1
2m
10m
OL-23890-01
network-clock output-source line priority {interface interface-name slot/card/port | controller
{t1 | e1} slot/card/port} {external slot/card/port [t1 {sf | esf | d4} | e1 [crc4| fas| cas [crc4] ] |
j1| 2m | 10m]
no network-clock output-source line priority {interface interface-name slot/card/port |
controller {t1 | e1} slot/card/port} {external slot/card/port [t1 {sf | esf | d4} | e1 [crc4| fas| cas
[crc4] ] | j1| 2m | 10m]
The priority of the clock source. The range is from 1 to 250.
Specifies the interface connected to the clock input.
The slot of Router/Switch where the clock source is present.
The bay in which card is inserted.
The port of the card.
Specifies the controller connected to the clock source.
Specifies the T1 controller.
Specifies the E1 controller.
The slot of Router/Switch where the clock source is present.
The bay in which card is inserted.
The port of the card.
Specifies an external interface.
The slot of Router/Switch where the clock source is present.
The bay in which card is inserted.
The port of the card.
Specifies a T1 interface.
Specifies SF framing on the T1 interface.
Specifies T1 ESF framing on the T1 interface.
Specifies D4 framing on the T1 interface.
Specifies an E1 interface.
Specifies CRC4 framing on the E1 interface.
Specifies FAS framing on the E1 interface.
Specifies CAS signaling on a T1 interface.
Specifies CRC4 framing on the E1 interface.
Specifies the J1 interface.
Specifies the 2 MHz interface.
Specifies the 10 MHz interface.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
network-clock output-source
267