Show Ethernet Cfm Smep - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

show ethernet cfm smep

To display connectivity fault management (CFM) system maintenance end point (SMEP) settings on a
device, use the show ethernet cfm smep command in privileged EXEC mode.
Syntax Description interface
gigabitethernet
number
Command Modes
Privileged EXEC (#)
Command History Release
12.2(33)SRD
15.0(1)XA
15.0(1)MR
Usage Guidelines
This command allows filtering on a per-interface basis.
Alarm Indication Signal (AIS) messages are sent by default at the configured maintenance intermediate
point (MIP) level if an AIS level is not configured.
Examples The following example shows sample output from the show ethernet cfm smep command:
Router# show ethernet cfm smep
SMEP Settings:
--------------
Interface: GigabitEthernet1/1
LCK-Status: CFM Disabled
LCK Period: 60000 (ms)
Level to transmit LCK: Default
AIS-Status: CFM Disabled
AIS Period: 60000 (ms)
Level to transmit AIS: Default
Defect Condition: No Defect
OL-23890-01
show ethernet cfm smep [interface gigabitethernet number]
(Optional) Displays information about an interface.
(Optional) Displays information about a Gigabit Ethernet interface.
(Optional)
Modification
This command was introduced.
This command was modified. Support for the port channel keyword was
introduced in Cisco IOS Release 15.0(1)XA.
This command was integrated into Cisco IOS Release 15.0(1)MR. This
release does not support the port channel keyword.
Integer from 1 to 6 that identifies a Gigabit Ethernet interface.
•
Integer from 1 to 564 that identifies a port channel.
•
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show ethernet cfm smep
509