Cisco MWR 2941 Command Reference Manual page 462

shape (percent)
Router(config-pmap)# class-map class1
Router(config-pmap-c)# shape average percent 25 20 ms be 100 ms bc 400 ms
Router(config-pmap-c)# end
After the policy map and class maps are configured, the policy map is attached to interface as shown in
the following example.
Router> enable
Router# configure terminal
Router(config)# interface serial4/0
Router(config-if)# service-policy input policy1
Router(config-if)# end
Related Commands Command
bandwidth
class (policy-map)
police (percent)
policy-map
priority
service-policy
shape max-buffers
show policy-map
interface
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
444
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Description
Specifies or modifies the bandwidth allocated for a class belonging to a
policy map.
Specifies the name of the class whose policy you want to create or change
and the default class (commonly known as the class-default class) before
you configure its policy.
Configures traffic policing on the basis of a percentage of bandwidth
available on an interface.
Creates or modifies a policy map that can be attached to one or more
interfaces to specify a service policy.
Gives priority to a class of traffic belonging to a policy map.
Attaches a policy map to an input interface or VC, or an output interface or
VC, to be used as the service policy for that interface or VC.
Specifies the maximum number of buffers allowed on shaping queues.
Displays the statistics and the configurations of the input and output
policies that are attached to an interface.
OL-23890-01