Service-Policy (Policy-Map Class) - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

service-policy (policy-map class)

To use a service policy as a QoS policy within a policy map (called a hierarchical service policy), use
the service-policy command in policy-map class configuration mode. To disable a particular service
policy as a QoS policy within a policy map, use the no form of this command.
Syntax Description policy-map-name
Command Default No service policies are used.
Command Modes Policy-map class configuration (config-pmap-c)
Command History Release
12.1(2)E
12.1(5)T
12.2(33)SRA
12.2SX
Cisco IOS XE
Release 2.1
12.4(20)MR
12.2(33)MRA
15.0(1)MR
Usage Guidelines This command is used to create hierarchical service policies in policy-map class configuration mode.
This command is different from the service-policy [input | output] policy-map-name command used in
interface configuration mode. The purpose of the service-policy [input | output] policy-map-name is to
attach service policies to interfaces.
The child policy is the previously defined service policy that is being associated with the new service
policy through the use of the service-policy command. The new service policy using the preexisting
service policy is the parent policy.
This command has the following restrictions:
•
•
OL-23890-01
service-policy policy-map-name
no service-policy policy-map-name
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.1(5)T.
This command was integrated into Cisco IOS Release 12.2(33)SRA.
This command is supported in the Cisco IOS Release 12.2SX train. Support
in a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
This command was implemented on Cisco ASR 1000 series routers.
This command was integrated into Cisco IOS Release 12.4(20)MR.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
The set command is not supported on the child policy.
The priority command can be used in either the parent or the child policy, but not both policies
simultaneously.
Specifies the name of the predefined policy map to be used as a QoS
policy. The name can be a maximum of 40 alphanumeric characters.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
service-policy (policy-map class)
399