Switchport Vlan Mapping Enable - Cisco MWR 2941 Command Reference Manual

switchport vlan mapping enable

switchport vlan mapping enable
To enable VLAN mapping per switch port, use the switchport vlan mapping enable command in
interface configuration mode. To disable VLAN mapping per switch port, use the no form of this
command.
Syntax Description This command has no arguments or keywords.
Defaults
VLAN mapping is disabled on all switch ports.
Command Modes
Interface configuration
Command History Release
12.2(17b)SXA
12.2(33)SRA
15.0(1)MR
Usage Guidelines
This command is not supported on Cisco 7600 series routers that are configured with a Supervisor
Engine 2.
You must enter the switchport vlan mapping enable command on the port where you want the mapping
Note
to take place.
The switchport vlan mapping enable command enables or disables VLAN-mapping lookup in the
hardware regardless of whether the mapping is configured by the global VLAN mapping command or
the switchport VLAN mapping command.
This command is useful on the hardware that supports VLAN mapping per ASIC only because you can
turn on or off VLAN translation selectively on ports that are connected to the same port ASIC.
Examples This example shows how to enable VLAN mapping per switch port:
Router(config-if)# switchport vlan mapping enable
This example shows how to disable VLAN mapping per switch port:
Router(config-if)# no switchport vlan mapping enable
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
664
switchport vlan mapping enable
no switchport vlan mapping enable
Modification
Support for this command was introduced on the Supervisor Engine 720.
This command was integrated into Cisco IOS Release 12.2(33)SRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01