Table of Contents
Advertisement
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
/subslot
/port
.subinterface
interface-type
interface-number
null 0
vlan vlan-id
detailed
class class-name
port-channel
channel-number
Command Default
This command displays the packet statistics of all classes that are configured for all service policies on
the specified interface or subinterface or on a specific permanent virtual circuit (PVC) on the interface.
The absence of both the forward slash (/) and a vpi value defaults the vpi value to 0. If this value is
omitted, information for all virtual circuits (VCs) on the specified ATM interface or subinterface is
displayed.
Command Modes
Privileged EXEC (#)
ATM Shared Port Adapter
User EXEC (>)
Privileged EXEC (#)
Command History
Release
12.0(5)T
12.0(5)XE
12.0(7)S
12.0(28)S
12.1(1)E
OL-23890-01
(ATM shared port adapter only) Secondary slot number on an SPA interface
processor (SIP) where a SPA is installed. See the platform-specific SPA
hardware installation guide and the corresponding "Specifying the Interface
Address on an SPA" topic in the platform-specific SPA software
configuration guide for subslot information.
(ATM shared port adapter only) Port or interface number. See the
appropriate hardware manual for port information. For SPAs, see the
corresponding "Specifying the Interface Address" topics in the
platform-specific SPA software configuration guide.
(ATM shared port adapter only—Optional) Subinterface number. The
number that precedes the period must match the number to which this
subinterface belongs. The range is 1 to 4,294,967,293.
(Optional) Interface type; possible valid values are ethernet, fastethernet,
gigabitethernet, tengigabitethernet, pos, atm, and ge-wan.
(Optional) Module and port number; see the "Usage Guidelines" section for
valid values.
(Optional) Specifies the null interface; the only valid value is 0.
(Optional) Specifies the VLAN ID; valid values are from 1 to 4094.
(Optional) Displays additional statistics.
(Optional) Displays the QoS policy actions for the specified class.
(Optional) Displays the EtherChannel port-channel interface.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.0(5)XE.
This command was integrated into Cisco IOS Release 12.0(7)S.
This command was modified for the QoS: Percentage-Based Policing feature
to include milliseconds when calculating the committed (conform) burst (bc)
and excess (peak) burst (be) sizes.
This command was integrated into Cisco IOS Release 12.1(1)E.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show policy-map interface
575
Advertisement
Table of Contents
