Ethernet Cfm Global - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

ethernet cfm global

To enable Ethernet connectivity fault management (CFM) globally on a device, use the ethernet cfm
global command in global configuration mode. To disable CFM globally on a device, use the no form
of this command.
Syntax Description This command has no arguments or keywords.
Command Default
Ethernet CFM is disabled.
Command Modes
Global configuration (config)
Command History Release
12.2(33)SXI2
12.2(33)SRE
15.0(1)MR
Usage Guidelines
Ethernet CFM is disabled by default and must be enabled explicitly. When CFM is configured, hardware
resources (for example, port-ASIC match registers) are allocated for CFM.
This command is supported only in the Ethernet CFM IEEE 802.1ag Standard implementation.
Examples
The following example shows how to enable CFM globally on a device:
Router(config)# ethernet cfm global
Related Commands Command
ethernet cfm ieee
OL-23890-01
ethernet cfm global
no ethernet cfm global
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.2(33)SRE.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Description
Enables the Ethernet Connectivity Fault Management 802.1ag
Standard (CFM IEEE) version of CFM.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ethernet cfm global
119