Maximum Meps - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

maximum meps

To specify the number of maintenance endpoints (MEPs) across the network in a maintenance
association, use the maximum meps command in Ethernet CFM service configuration mode. To restore
the default value, use the no form of this command.
Syntax Description max-num
Command Default
A maximum number of MEPs is not configured.
Command Modes
Ethernet CFM service configuration (config-ecfm-srv)
Command History Release
12.2(33)SXI2
12.2(33)MRA
15.0(1)MR
Usage Guidelines When the configured maximum is reached, continuity check messages (CCMs) from other remote MEPs
are ignored and a warning message is displayed.
Output of the show running all command displays "maximum meps 100" when the default value is
configured.
Examples The following example shows how to configure a maximum of 50 MEPs:
Router(config)# ethernet cfm domain operatorA level 5
Router(config-ether-cfm)# service vlan-id 5 port
Router(config-ether-cfm)# maximum meps 50
Related Commands Command
show running all
OL-23890-01
maximum meps max-num
no maximum meps
Integer from 1 to 65535. The default is 100.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Description
Shows the running configuration with default values.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
maximum meps
235