Table of Contents
Advertisement
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show link-protection statistics
To display the counters for each link protection port, use the show link-protection statistics command
in user EXEC or privileged EXEC mode.
Syntax Description
interface
interface-name
slot
port
Command Modes
User EXEC (>)
Privileged EXEC (#)
Command History
Release
15.0(1)MR
Usage Guidelines
This command only applies to Gigabit Ethernet interfaces.
Use this command to configure Microwave 1+1 Hot Standby Protocol (HSBY). For more information
about HSBY, see the
Release
Examples
The following examples provide sample output from the show link-protection statistics command:
Router# show link-protection statistics
Counters:
---------
Port: Gi0/1
Group: 1
TLV Rx: 683
TLV Tx: 685
TLV Rx: 0
Invalid TLV Rx: 0
Sender OK Rx: 0
Sender KO Rx: 0
Suspend Flag Rx: 0
ODU Failure: 1
Port: Gi0/2
Group: 1
TLV Rx: 680
TLV Tx: 698
Invalid TLV Rx: 0
Sender OK Rx: 0
Sender KO Rx: 0
Suspend Flag Rx: 0
ODU Failure: 1
OL-23890-01
show link-protection statistics [interface interface-name slot/port]
Specifies the interface connected to the clock input.
The name of the interface connected to the clock input.
The slot in which card is inserted.
The port of the card.
Modification
This command was introduced.
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide,
15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show link-protection statistics
551
Advertisement
Table of Contents
