Network-Clock-Select Mode - Cisco MWR 2941 Command Reference Manual

network-clock-select mode

network-clock-select mode
The network-clock-select mode command specifies the router switching mode when recovering from a
failure. To remove a network-clock-select mode configuration, use the no form of this command.
Syntax Description
nonrevert
revert
Defaults The default setting is network-clock-select mode nonrevert.
Command Modes Global configuration
Command History Release
12.4(19)MR2
12.2(33)MRA
15.0(1)MR
Examples
The following example shows how to use the network-clock-select command:
Router# config t
Router(config)# network-clock-select mode revert
Router(config)# exit
Related Commands Command
set network-clocks
force-reselect
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
286
network-clock-select mode {revert | nonrevert}
no network-clock-select mode {revert | nonrevert}
Sets the network clock to non-revertive mode.
Sets the network clock to revertive mode.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Description
Forces the router to re-select the network clock.
OL-23890-01