Ptp Min-Timing-Pkt-Size - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

ptp min-timing-pkt-size

This command allows you to modify the default size of PTP timing packets; in some conditions,
modifying the PTP packet size can improve clock recovery performance.
Syntax Description
size
Defaults
The default timing packet size is 86 bytes.
Command Modes
Global configuration
Command History Release
12.4(19)MR2
12.2(33)MRA
15.0(1)MR
Usage Guidelines This command is not part of the IEEE-2008 PTP standard.
Examples
The following example shows how to enable ptp master multicast mode:
Router# config t
Router(config)# ptp min-timing-pkt-size 100
Router(config)# exit
Related Commands Command
ptp clock-destination
ptp enable
ptp mode
OL-23890-01
ptp min-timing-pkt-size size
no ptp min-timing-pkt-size size
Specifies the minimum PTP timing packet size in bytes. Valid values are
86–1510. The default value is 86.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Description
Specifies the IP address of a clock destination when the router is in
PTP master mode.
Enables PTP mode on an interface.
Specifies the PTP mode.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ptp min-timing-pkt-size
345