Network-Clock Source Quality-Level - Cisco MWR 2941 Command Reference Manual

network-clock source quality-level

network-clock source quality-level
To specify a quality level for a clock source, use the network-clock source quality-level command in
interface configuration mode. To remove a quality-level configuration, use the no form of this
command.
Syntax Description tx
rx
value
Command Default
This command is disabled by default.
Command Modes
Global configuration (config)
Command History Release
15.0(1)MR
Usage Guidelines
You can use this command to override the quality level value of a network clock; the command inserts
a value into the local clock selection process that is considered as a value received from the network.
Examples This example shows how to configure a network clock source quality level:
Router# configure terminal
Router(config)# interface gigabitethernet 0/1
Router(config-if) network-clock source quality-level ql-prc tx
Router(config-if)# end
Router#
Related Commands Command
network-clock
input-source
network-clock
output-source
network-clock
quality-level
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
274
network-clock source quality-level {tx | rx} value
no network-clock source quality-level {tx | rx} value
Specifies a quality level for transmitted traffic.
Specifies a quality level for received traffic.
Defines the quality level. Valid values are: QL-PRC, QL-SSU-A, QL-SSU-B,
QL-SEC, and QL-DNU.
Modification
This command was introduced.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Description
Selects an interface or external timing input as a clock source and sets a
priority for the clock.
Transmits clocking to an external timing source using a timing output
interface.
To specify a quality level for a line or external timing device.
OL-23890-01