Table of Contents
Advertisement
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
set ip tos (route-map)
To set the type of service (ToS) bits in the header of an IP packet, use the set ip tos command in
route-map configuration mode. To leave the ToS bits unchanged, use the no form of this command.
Syntax Description
tos-bit-value
max-reliability
max-throughput
min-delay
min-monetary-cost
normal
Command Default
Disabled
Command Modes
Route-map configuration
Command History
Release
11.2
12.4T
12.2(33)SRA
12.2SX
12.4(20)MR
12.2(33)MRA
15.0(1)MR
Usage Guidelines
This command allows you to set four bits in the ToS byte header.
bits in binary form.
Table 12
T3
0
0
OL-23890-01
set ip tos [tos-bit-value | max-reliability | max-throughput | min-delay | min-monetary-cost |
normal]
no set ip tos
(Optional) A value (number) from 0 to 15 that sets the ToS bits in the IP
header. See
(Optional) Sets the maximum reliability ToS bits to 2.
(Optional) Sets the maximum throughput ToS bits to 4.
(Optional) Sets the minimum delay ToS bits to 8.
(Optional) Sets the minimum monetary cost ToS bits to 1.
(Optional) Sets the normal ToS bits to 0.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.4T.
This command was integrated into Cisco IOS Release 12.2(33)SRA.
This command is supported in the Cisco IOS Release 12.2SX train. Support
in a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
This command was integrated into Cisco IOS Release 12.4(20)MR.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
ToS Bits and Description
T2
T1
T0
0
0
0
0
0
1
Table 12
for more information.
Description
0 normal forwarding
1 minimum monetary cost
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
set ip tos (route-map)
Table 12
shows the format of the four
431
Advertisement
Table of Contents
