Network-Clock Synchronization Mode Ql-Enabled - Cisco MWR 2941 Command Reference Manual

network-clock synchronization mode ql-enabled

network-clock synchronization mode ql-enabled
To configure automatic selection of a clock source based on quality level (QL), use the network-clock
synchronization mode ql-enabled command in configuration mode. To disable clock selection based
on quality level, use the no form of this command.
Syntax Description No arguments or keywords.
Command Default
Source selection based on quality level is disabled by default.
Command Modes
Global configuration (config)
Command History Release
15.0(1)MR
Usage Guidelines Enabling clock selection based on quality level requires a synchronization interface that can send SSM
messages.
Examples
This example shows how to enable QL-enabled synchronization mode:
Router(config)# network-clock synchronization mode QL-enabled
Router(config)#
Related Commands Command
synchronous mode
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
276
network-clock synchronization mode QL-enabled
no network-clock synchronization mode QL-enabled
Modification
This command was introduced.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Description
To set an Ethernet interface in synchronous mode
OL-23890-01