Tunnel Destination - Cisco MWR 2941 Command Reference Manual

tunnel destination

tunnel destination
To specify the destination for a tunnel interface, use the tunnel destination command in interface
configuration mode. To remove the destination, use the no form of this command.
Syntax Description
host-name
ip-address
Command Default No tunnel interface destination is specified.
Command Modes Interface configuration
Command History Release
10.0
12.3(7)T
12.2(30)S
12.2(28)SB
12.2(25)SG
12.2(33)SRA
12.2SX
12.4(20)MR
12.2(33)MRA
15.0(1)MR
Usage Guidelines You cannot configure two tunnels to use the same encapsulation mode with exactly the same source and
destination address. The workaround is to create a loopback interface and configure the packet source
off of the loopback interface.
Examples Tunnel Destination Address for GRE Tunneling Example
The following generic routing encapsulation (GRE) example shows how to configure the tunnel
destination address for GRE tunneling:
Router(config)# interface tunnel0
Router(config-if)# tunnel source ethernet0
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
670
tunnel destination {host-name | ip-address}
no tunnel destination
Name of the host destination.
IP address of the host destination expressed in dotted decimal notation.
Modification
This command was introduced.
The address field was modified to accept an ipv6-address argument to allow
IPv6 nodes to be configured as a tunnel destination.
This command was integrated into Cisco IOS Release 12.2(30)S.
This command was integrated into Cisco IOS Release 12.2(28)SB.
This command was integrated into Cisco IOS Release 12.2(25)SG.
This command was integrated into Cisco IOS Release 12.2(33)SRA.
This command is supported in the Cisco IOS Release 12.2SX train. Support
in a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
This command was integrated into Cisco IOS Release 12.4(20)MR.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01