Cos (Cfm) - Cisco MWR 2941 Command Reference Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR

cos (CFM)

To set the class of service (CoS) for a maintenance endpoint (MEP) that will be sent in Ethernet
connectivity fault management (CFM) messages, use the cos command in the Ethernet CFM interface
configuration mode. To set the CoS to the highest priority allowed on the interface, use the no form of
this command.
Syntax Description
cos-value
Command Default If this command is not configured, the default CoS value is used.
Command Modes Ethernet CFM interface configuration (config-if-ecfm-mep)
Command History Release
12.2(33)SXI2
12.2(33)SRE
15.0(1)MR
Usage Guidelines
This command is used to set the priority of messages.
CoS may not be supported on all platforms.
Examples
The following example shows how to set the CoS to 5:
Router(config)# ethernet cfm domain test level 5
Router(config-ecfm)# service vlan-id 17 vlan 17
Router(config-ecfm-srv)# exit
Router(config-ecfm)# exit
Router(config)# interface gigabitethernet 0/2
Router(config-if)# ethernet cfm mep domain test mpid 5 vlan 17
Router(config-if-ecfm-mep)# cos 5
Router(config-if-ecfm-mep)#
OL-23890-01
cos cos-value
no cos
Integer from 0 to 7 that identifies the CoS. The default is 0.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.2(33)SRE.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
cos (CFM)
97