Table of Contents
Advertisement
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show network-clocks synchronization
To display a the synchronization status of a network clock, use the show network-clock
synchronization command in privileged Exec mode.
Related Commands
interface
interface-name
slot
card
port
interface-name
external
slot
card
port
controller
slot
card
port
global
top
slot
card
port
session
detail
Command Modes
Privileged EXEC
Command History
Release
15.0(1)MR
Examples
The following example shows how to display the synchronization status for a network clock.
OL-23890-01
show network-clock synchronization [[[interface interface-name slot/card/port | external
slot/card/port | controller slot/card/port] | global | top slot/card/port/session] detail]
Specifies the interface connected to the clock input.
The name of the interface connected to the clock input.
The slot of Router/Switch where the clock source is present.
The bay in which card is inserted.
The port of the card.
The name of the interface connected to the clock input.
Specifies an external interface.
The slot where the clock source is present.
The bay in which card is inserted.
The port of the card.
Specifies the controller of the network clock source.
The slot where the clock source is present.
The bay in which card is inserted.
The port of the card.
Displays global parameters.
Specifies the timing over packet (ToP) interface.
The slot of Router/Switch where the clock source is present.
The bay in which card is inserted.
The port of the card.
The session on the TOP interface.
Note
If the session ID is not required to identify the clock source, enter 0.
The IEEE 1588 standard permits two clock sources per port; use the session
Note
keyword to distinguish between two clocks on one port.
Provides additional detail about a network clock synchronization status.
Modification
This command was introduced.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show network-clocks synchronization
563
Advertisement
Table of Contents
