Table of Contents
Advertisement
show policy-map interface
Release
12.1(2)T
12.1(3)T
12.2(4)T
12.2(8)T
12.2(13)T
12.2(14)SX
12.2(15)T
12.2(17d)SXB
12.3(14)T
12.2(18)SXE
12.4(4)T
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
578
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
Modification
This command was modified to display information about the policy for all
Frame Relay PVCs on the interface or, if a DLCI is specified, the policy for
that specific PVC. This command was also modified to display the total
number of packets marked by the quality of service (QoS) set action.
This command was modified to display per-class accounting statistics.
This command was modified for two-rate traffic policing and can display
burst parameters and associated actions.
The command was modified for the Policer Enhancement—Multiple
Actions feature and the WRED—Explicit Congestion Notification (ECN)
feature.
For the Policer Enhancement—Multiple Actions feature, the command was
modified to display the multiple actions configured for packets conforming
to, exceeding, or violating a specific rate.
For the WRED—Explicit Congestion Notification (ECN) feature, the
command displays ECN marking information.
The following modifications were made:
This command was modified for the Percentage-Based Policing and
•
Shaping feature.
This command was modified for the Class-Based RTP and TCP Header
•
Compression feature.
•
This command was modified as part of the Modular QoS CLI (MQC)
Unconditional Packet Discard feature. Traffic classes in policy maps
can now be configured to discard packets belonging to a specified class.
This command was modified to display the Frame Relay DLCI number
•
as a criterion for matching traffic inside a class map.
•
This command was modified to display Layer 3 packet length as a
criterion for matching traffic inside a class map.
•
This command was modified for the Enhanced Packet Marking feature.
A mapping table (table map) can now be used to convert and propagate
packet-marking values.
Support for this command was introduced on Cisco 7600 series routers.
This command was modified to display Frame Relay voice-adaptive
traffic-shaping information.
This command was implemented on the Supervisor Engine 2 and integrated
into Cisco IOS Release 12.2(17d)SXB.
This command was modified to display bandwidth estimation parameters.
This command was integrated into Cisco IOS Release 12.2(18)SXE. This
command was modified to display aggregate WRED statistics for the ATM
shared port adapter. Note that changes were made to the syntax, defaults, and
command modes. These changes are labelled "ATM Shared Port Adapter."
The type access-control keywords were added to support flexible packet
matching.
OL-23890-01
Advertisement
Table of Contents
