Mep Crosscheck Mpid Vlan - Cisco MWR 2941 Command Reference Manual

mep crosscheck mpid vlan

mep crosscheck mpid vlan
To statically define a remote maintenance endpoint (MEP) within a maintenance domain, use the mep
crosscheck mpid vlan command in Ethernet CFM configuration mode. To delete a remote MEP, use
the no form of this command.
Syntax Description id
vlan-id
mac
mac-address
Command Default
No remote MEPs are configured.
Command Modes
Ethernet CFM configuration (config-ether-cfm)
Command History Release
12.2(33)SRA
12.4(11)T
12.2(33)SXH
12.2(33)MRA
15.0(1)MR
Usage Guidelines Use the mep crosscheck mpid vlan command to statically configure remote MEPs that are part of a
domain. These remote MEPs can be used in the cross-check operation. The cross-check operation only
works when local MEPs are configured that correspond to the statically configured remote MEPs.
Examples The following example shows how to define a MEP within a maintenance domain with an ID of 20, in
VLAN 5, and with MAC address a5a1.a5a1.a5a1:
Router(config-ether-cfm)# mep crosscheck mpid 20 vlan 5 mac a5a1.a5a1.a5a1
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
238
mep crosscheck mpid id vlan vlan-id [mac mac-address]
no mep crosscheck mpid id vlan vlan-id [mac mac-address]
Integer in the range of 0 to 8191 that forms the maintenance point ID
(MPID).
Integer in the range of 1 to 4094 that identifies the VLAN.
(Optional) Indicates that the MAC address of the MEP is specified.
(Optional) MAC address in the format abcd.abcd.abcd.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.4(11)T.
This command was integrated into Cisco IOS Release 12.2(33)SXH.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01