Traceroute Ethernet - Cisco MWR 2941 Command Reference Manual

traceroute ethernet

traceroute ethernet
To send Ethernet connectivity fault management (CFM) traceroute messages to a destination
maintenance endpoint (MEP), use the traceroute ethernet command in privileged EXEC mode. This
command does not have a no form.
Syntax Description
mac-address
mpid
mpid
domain
domain-name
evc
evc-name
port
vlan
vlan-id
cos
value
fdb-only
source
Command Modes
Privileged EXEC (#)
Command History Release
12.2(33)SXI2
12.2(33)SRE
12.2(33)MRA
15.0(1)MR
Usage Guidelines
If a CoS is not configured, the default is the highest priority allowed for the egress interface.
FDB is another term for the L2 forwarding table. When the fdb-only option is configured, only MAC
addresses learned in a bridge's FDB (not information saved in the maintenance intermediate point [MIP]
continuity check database [CCDB]) are used to determine the egress port.
The destination can be either a MEP or a MIP. If the destination is a MIP, the FDB must have a MAC
address entry for that MIP; that is, the FDB has learned the MIP's MAC address via Linktrace responses.
For a bridge domain-VLAN service, the VLAN ID can be used to initiate traceroute.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
668
traceroute ethernet {mac-address | mpid mpid} {domain domain-name {evc evc-name | port |
vlan vlan-id}} [cos value] [fdb-only | source mpid]
MAC address of a remote MEP in the format abcd.abcd.abcd.
Specifies a destination MEP.
Integer from 1 to 8191 that identifies the MEP.
Specifies the domain in which the destination MEP resides.
String of a maximum of 154 characters that identifies the domain.
Specifies an Ethernet virtual circuit (EVC).
String that identifies the EVC.
Specifies a DOWN service with no VLAN association (untagged).
Specifies a VLAN.
Integer from 1 to 4094 that identifies the VLAN.
(Optional) Specifies a class of service (CoS).
(Optional) Integer from 0 to 7 that identifies the CoS.
(Optional) Specifies the forwarding database (FDB) table.
(Optional) Specifies a source MEP.
Modification
This command was introduced.
This command was modified. Support for the evc keyword was added in
Cisco IOS Release 12.2(33)SRE.
This command was integrated into Cisco IOS Release 12.2(33)MRA.
This command was integrated into Cisco IOS Release 15.0(1)MR.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01