Table 4-18 List Of Initial Values That Can Be Set Using Qos Information And Initial Values During Initial Installation - Hitachi GR2000 Series Configuration Commands

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Table 4-18 List of Initial Values That Can Be Set Using QoS Information and Initial
Information
Group Name
QoS
information
4-58
Values During Initial Installation
Information Name
Queue mode of queue list
Number of queues in which the band is equally
assigned when the queue mode of a queue list
is a minimum equal band guarantee
Maximum number of queues when the queue
mode of a queue list is a minimum band
guarantee (specified in kbit/s)
Minimum band when the queue mode of a
queue list is a minimum band guarantee
(specified in kbit/s)
Discard mode
Check of source and destination IP addresses
Check of source and destination upper protocol
port numbers
Sequential check of IP address and upper
protocol port number
Designation of maximum output priority class
Designation of output priority class (for IP)
Designation of queuing priority class (for IP)
Designation of output priority class (for IPX)
Designation of queuing priority class (for IPX)
Designation of output priority class (for bridge)
Designation of queuing priority class (for bridge) Class 4
Designation of output priority class (for hdlc)
Designation of queuing priority class (for hdlc)
Initial Value
Output priority control
24
8
0
Discard mode 3
The source and destination IP
addresses are checked for
replacement without replacement.
The source and destination upper
protocol port numbers are checked
for replacement without
replacement.
The source and destination IP
addresses, and source and
destination upper protocol port
numbers are simultaneously
checked without replacement,
respectively.
8
Class 4
Class 4
Class 4
Class 4
Class 4
Class 4
Class 4
GR2K-GA-0014
Ver. 07-02