Table 1-21 List Of Parameters That Can Be Set For Each Rp Type Using Ipv4 Filter Flow Information - Hitachi GR2000 Series Configuration Commands

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Table 1-21 List of Parameters that Can Be Set for Each RP Type Using IPv4 Filter Flow
Item
Main item Sub-item
Flow All protocol IPs
detection
Protocol number
conditions
Protocol TCP
Protocol UDP
Protocol ICMP
Protocol IGMP
Source IP address
Destination IP address
DSCP
precedence
IP user data length
Source port number
Destination port number <Port_Destination>
ack flag
syn flag
ICMP type
ICMP code
IGMP type
VLAN ID
Designation Relay
of operation
Discard
Policy routing
Policy routing loop
DSCP
Connection branch
: Can be set.
-: Cannot be set.
*1: Cannot be set for multi-cast.
<Interface Name>
The subject interface name set in the IP information or the IP-address
information is designated. (The IP information or IP-address information should
have been set before inputting this command.) The RM Ethernet is not
supported. For details, refer to Table 1-5.
Default:
1-28
Information
Parameter
ip
<protocol No.>
tcp
udp
icmp
igmp
<IP_Source>
<IP_Destination>
dscp <DSCP_Value>
precedence
<precedence_Value>
{upper | lower}
<Length>
<Port_Source>
ack
syn
<ICMP_Type>
<ICMP_Code>
<IGMP_Type>
vlan <VLAN_ID>
forward
drop
policy <Interface
Name> <IP Address>
policy_group
<policy-Group-Name>
replace_dscp
<DSCP_Value>
index <No.>
No default is possible.
RP-A1 RP-C, RP-D
Input Output Input
side side side
RP-C6, RP-D6
RP-CV, RP-DV
GR2000-1B,
GR2000-2B,
GR2000-2B+,
GR2000-BH
Output Input Output
side side side
GR2K-GA-0014
Ver. 07-02