Hitachi GR2000 Series Configuration Commands page 262

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Description:
Default:
Range of value:
Description:
Default:
Range of value:
Description:
Default:
Range of value:
Description:
Default:
Range of value:
Description:
Default:
Range of value:
Description:
Default:
Range of value:
1-220
This parameter sets the IP address of a primary server.
This parameter cannot be omitted.
IPv4 address (nnn.nnn.nnn.nnn): 0.0.0.0 to 255.255.255.255
This parameter sets the port number of a primary server.
3101
0 to 65535 (decimal)
This parameter sets the IP address of a backup server.
This parameter is set to non-specification.
IPv4 address (nnn.nnn.nnn.nnn): 0.0.0.0 to 255.255.255.255
This parameter sets the port number of a backup server.
3101
0 to 65535 (decimal)
This parameter sets the server password (encryption key).
Set cops_password when setting this parameter.
This parameter is set to non-specification.
keyid: 1 to 2147483647 (7FFFFFFF)
A character string of a password exceeding one character and
not exceeding 64 characters is set using double quotation
marks ("). Alphanumeric characters and special characters
can be entered. However, a character string can be entered
without using double quotation marks (") when no special
character (e.g., space) is contained in an entry character
string.
However, notice that the characters below cannot be used.
"(double quotation mark), { (beginning of brace), } (end of
brace), ' (single quotation mark), ; (semicolon), $ (dollar), and '
(reverse single quotation mark). For more information, see
Table 1-102
This parameter sets the COPS password (encryption key).
Set server_password when setting this parameter.
This parameter is set to non-specification.
keyid: 1 to 2147483647 (7FFFFFFF)
Set different values to five keyids, respectively.
A character string of a password exceeding one character and
not exceeding 64 characters is set using double quotation
GR2K-GA-0014
Ver. 07-02