Hitachi GR2000 Series Configuration Commands page 297

Description:
Default:
Range of value:
Description:
Default:
Range of value
Description:
Default:
Description:
Default:
Examples
1. Parameter configuration
To set the interface sk1 as a spanning-tree bridge interface:
GR2K-GA-0014
Ver. 07-02
You can assign a cost parameter to calculate best path from
each interface to the root bridge. This parameter determines
which bridge interface offers a lower-cost path to the root
bridge. This parameter is valid only for interfaces with
Spanning Tree turned "on".
10
1-65535
You can define the upper 8 bits of port ID (16 bits). Use port ID
to decide which interface should do the Frame Relay when two
or more interfaces on the same bridge are connected to the
same network.
128
0-255
You can define whether the transition state of the relevant
interface is active or not. With
Frame Relay of the specified frame. This parameter is valid
only for interfaces with bridge mode operational (
-enable
You can select the function to translate FDDI frame into the
ether frame format when transmitting to WAN or ATM. This
parameter is valid only when the specified interface is WAN or
ATM. This parameter supports only the bridge, connected with
the specified ether interface. Use it if you cannot recognize
FDDI frame.
The translation of frame format described here is only for MAC
header (regularized with IEEE802.1H), which does not support
partitioning a frame (fragmentation) in the bridge.
-translation_off indicates no translation; -translation indicates
translation.
-translation_off
IPX/Bridge Information
, you can prohibit
-disable
-spt
).
2-31