Hitachi GR2000 Series Configuration Commands page 495

Table 5-25 Other Error Messages (continued)
Current configuration file was successfully
changed. Configuration file do not modified to
standby RM because configuration file is
opened in standby RM.
Current configuration file was successfully
changed. Configuration file do not modified to
standby RM because standby RM is not
ready.
Current configuration file was successfully
saved. Update configuration file do not copy
to standby RM because standby RM is not
ready.
Current configuration file was successfully
saved. Update configuration file do not
modified to standby RM because cached
configuration file create failed.
Current configuration file was successfully
saved. Update configuration file do not
modified to standby RM because
configuration file copy failed.
Current configuration file was successfully
saved. Update configuration file do not
modified to standby RM because
configuration file is opened in standby RM.
Current configuration file was successfully
saved. Update Configuration file do not
modified to standby RM because standby RM
is not ready.
Device out of space.
File exists.
Filename or directory path is too long.
Input/output error.
Is a directory.
Not enough memory, configuration file is too
big.
No such file or directory.
GR2K-GA-0014
Ver. 07-02
Current configuration information file was copied, but because
standby configuration file is opened, standby configuration
information is not reflected. When updating standby configuration
information, close standby configuration, and then use config copy
command.
Current configuration information file was copied, but because
standby configuration file cannot be modified, standby configuration
information is not reflected. When updating standby configuration
information, confirm standby status and operation, and then reflect
standby configuration information by using config command.
Current configuration information file was saved, but because
standby RM is not setup, standby configuration information is not
reflected. When updating standby configuration information, use
copy command after setup the standby.
Current configuration information file was saved, but because
standby configuration information cannot be copied to cached
configuration file, standby configuration information is not reflected.
When updating standby configuration information, confirm the rest
memory size of standby MC card by using show mc command, and
reflect standby configuration information by using copy command
after eliminating causes of error.
Current configuration information file was saved, but because this
current configuration file cannot be copied to standby configuration
information file, standby configuration information is not reflected.
When updating standby configuration information, confirm setting
status and the rest memory size of standby MC card by using show
mc command, and reflect standby configuration information by using
copy command after eliminating causes of error.
Current configuration information file was saved, but because
standby configuration file is opened, standby configuration
information is not reflected. When updating standby configuration
information, close standby configuration, and then use config copy
command.
Current configuration information file was saved, but because
standby configuration file cannot be modified, standby configuration
information is not reflected. When updating standby configuration
information, confirm standby status and operation, and then reflect
standby configuration information by using config command.
Because the memory of MC card running short, data can not be
saved to specified file. Delete unnecessary file of MC card.
Specified file name can not be used. Specify another file name.
The spare configuration filename or directory path exceeds 256
characters. Shorten the spare configuration filename or directory
path.
Access to MC card failed. Confirm setting status of MC card by using
show mc command. When MC card is set correctly, wait for access,
then execute again.
Because specified file name is directory, it can not be used. Enter a
correct file name.
Because current or spare configuration file is too big, memory size is
insufficient. Using the editor, delete unnecessary definitions in the
configuration definition information file.
Confirm RM memory using the "show router" command (*3) and, if
RM memory is less than 256Mb, increase it to 256Mb or more and
then edit the configuration information again.
Specified file or directory not exist. Enter correct file name or
directory.
Configuration Error Messages
5-105