Tunnel Interface Information - Hitachi GR2000 Series Configuration Commands

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Table 4-12 List of Initial Values That Can Be Set Using ISDN Information and Initial
Information
Group Name
ISDN
information
(continued)
4.7.13

Tunnel Interface Information

Input Format
Parameters
The initial value items that can be set using tunnel Information and the initial values
during initial installation are shown in Figure 1-7.
4-50
Values During Initial Installation (continued)
Information Name
Report of local IPX node number
Transmission interval of Echo-RQ frame
Type of certified protocol
Overload connection procedure
Monitoring interval of line usage rate during overloading
based on monitoring of line usage rate
Direction for monitoring of line usage rate
Operation of resource BOD
Number of ISDN backup connection retries when a
failure is detected during connection of ISDN at the
backup destination using resource BOD
Route change-back procedure of resource BOD
Request of telephone number report to the remote
router when a link is added in BAP using an outgoing
call
Initial value of remote MTU length when using multi-link
PPP procedure
Request retry interval when the request of link addition
and deletion is rejected in BAP
Backup change-back operation
Surveillance time for manual cut-back.
ISDN logical port backup switchover and switchback
action
Initial Value
The local IPX node number
is not reported.
3 seconds
No certified protocol is used.
Multi-link PPP connection
The overloading based on
the monitoring of a line
usage rate is not performed.
Only the line usage rate
during transmission is
monitored.
Resource BOD is
performed.
3 times
The route is changed back
automatically.
No telephone number is
requested.
4500 bytes
60 seconds
Automatic change-back
80 seconds
Executes call connection
prompted by information
generation at the time of
switchover and executes
call disconnection prompted
by the detection of
no-communication status in
information monitoring at
the time of switchback.
GR2K-GA-0014
Ver. 07-02