Hitachi GR2000 Series Configuration Commands page 245

3. Changing parameters
To change IP frame condition group names from
office1:
4. Displaying settings
To display the setting contents of the interface named
5. Deleting settings
To delete inbound settings of the interface named
Related Commands
qos
qos-queue-list
qos-interface
qos-discard-mode
qos-ip-list
qos-ip-list-group
qos-tos-map
ip
ip-address
Related Information
For the flow control, refer to the GR2000 Applications Guide.
Precaution
1. Figure 1-12 shows the effect of QoS configuration definition output priority
setting in ATM line. The output priority setting is valid in group name that
grouped VC tokyo1 and Inbound (frame input side) of VC name tokyo2, but
invalid in Outbound (frame output side) because ATM line does not control
sending control. When output priority is set to Inbound of Ethernet, WAN, or
ATM line, the setting is invalid at sending by ATM line. For example, when output
priority is set in Inbound of line name tokyo4, it is valid at outputting packet
received from the target line to line name tyokyo3 (WAN line), but invalid at
outputting to tokyo1 or tokyo2 (ATM line).
GR2K-GA-0014
Ver. 07-02
Filtering/QoS Information
to in the interface named
ip1 ip3
:
office1
:
office1
1-203