Hitachi GR2000 Series Configuration Commands page 451

Table 5-6
pim: the total number of enable interfaces is
more than the maximum number of interfaces
that this router runs (<Num1>) though it is less
than the max-interfaces value (<Num2>)
pim: the total number of groups on
candidate-rp is more than the maximum
permitted (128)
pim: the total number of interfaces is more
than the maximum permitted (<Num>)
pim:the number of PIM-SSM groups is set up
exceeding the maximum
pim: this address is not supported <Group
address>
<Command>: syntax error
GR2K-GA-0014
Ver. 07-02
Multicast Router Control Information Error Messages (continued)
The total number of interface addresses set to "enable" in the PIM
definition does not exceed the value (<Num2>) specified for
max-interfaces. But the number exceeds the maximum number of
interfaces running on the system (<Num1>). Set the number of
enable-specified interface addresses to <Num1> or less.
To add an interface definition, take the following steps:
(1) Execute the config apply command.
(2) Execute the restart ipv4-multicast command.
(3) Add an interface address of PIM.
<Num1>: The maximum number of interfaces running on the system.
<Num2>: The number of specified interfaces.
The total number of group addresses of rendezvous point candidates
exceeds the maximum capacity. Specify 128 addresses or less.
The total number of interface addresses specified in the PIM
definition exceeds the maximum capacity. Set the number of PIM
addresses to <Num> or less.
<Num>: The maximum number of specified interfaces
The number of PIM-SSM group addresses that have been set
exceeds the maximum limit. The maximum number is 1.
The group address specified for PIM-SAM rendezvous point
candidates is not supported. For the group address, specify a
Class-D IP address.
<Group address>: Specified multicast group address
Syntax error
<Command>: Command name
Configuration Error Messages
5-61