Hitachi GR2000 Series Configuration Commands page 409
Hitachi gigabit router configuration guide
Hide thumbs
Also See for GR2000 Series:
- Installation manual (18 pages) ,
- Installation manual (410 pages)
Table of Contents
Advertisement
Table 5-4
This interface is multihome/please use
ip-address object.
Virtual router ip address not specified.
Cannot utilize IPv6 and VPN option
simultaneously.
6to4 tunnel configuration is already defined.
Invalid 6to4 tunnel IPv6 address.
IPv4 address cannot change because used by
6to4 tunnel.
IPv4 address cannot delete because used by
6to4 tunnel.
IPv4 address not defined.
IPv4 address is not global or not unicast.
6to4 address is invalid. 6to4 address must
start "2002".
GR2K-GA-0014
Ver. 07-02
IP Information Error Messages (continued)
Because this interface is configuration information of multihome,
it cannot be set. Set by using ip-address object.
Virtual router ip address not specified. Set Virtual router ip address.
It is not possible to simultaneously set IPv6 addresses and VPN IDs.
Do not set them simultaneously.
An IPv6 address is already set in the 6to4 tunnel.
It is not possible to set multiple IPv6 addresses in a 6to4 tunnel.
The address defined in the 6to4 tunnel is invalid as an IPv6 address.
It is not possible to set IPv4 addresses in 6to4 tunnels.
It is not possible to change since it is an IPv4 address contained in
the IPv6 address of the 6to4 tunnel.
First change the IPv6 address of the 6to4 tunnel or delete the
configuration definition of the 6to4 tunnel.
It is not possible to delete since it is an IPv4 address contained in the
IPv6 address of the 6to4 tunnel.
First change the IPv6 address of the 6to4 tunnel or delete the
configuration definition of the 6to4 tunnel.
The IPv4 address contained in the IPv6 address of the 6to4 tunnel
that you attempted to define is not defined.
When defining 6to4 tunnels, specify an IPv6 address containing an
IPv4 address that is already defined.
The IPv4 address contained in the IPv6 address of the 6to4 tunnel
that is being defined is not a global address.
When defining 6to4 tunnels, specify an IPv6 address containing a
global unicast IPv4 address.
The IPv6 address of the 6to4 tunnel that is being defined does not
begin with 2002. Use an address with the prefix 2002::/16 for the
IPv6 address specified in the 6to4 tunnel.
Configuration Error Messages
5-19
Advertisement
Table of Contents
