Hitachi GR2000 Series Configuration Commands page 50

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Table 1-5
Interface Name
<Line Name>
rmEthernet
<DLCI Name>
<VC Name>
<Group Name>
<Timeslot Name>
<Peer Name>
<Tunnel Name>
<VLAN Name>
<Session Name>
÷: Setting possible.
-: Setting impossible
*1: PPPoE session (input side) are not supported.
*2: Only 1 session is supported.
Cautions during BCU replacement
RP is rebooted when BCU replacement is executed in devices in which the flow
configuration information of the current configuration definition information has
been changed. In order to limit RP reboots during the BCU replacement, execute the
procedure below for the active system BCU.
1. Config save configuration definition command entry
2. Config close configuration definition command entry
3. Config copy configuration definition command entry
Example: config copy/mc0/config/router.caf primary
4. Execute BCU replacement
Types of action that have an affect when using filter flow information and QoS flow
information in combination
The activation priority when using filter flow information and QoS flow information in
combination in the same interface is as indicated below (*1).
Input filter < input QoS < output filter < output QoS
Therefore, when using in combination with DSCP rewrite or connection branch when
filter flow information or QoS flow information activation is specified, the setting with
the highest activation priority is enabled. When setting policy with filter flow
information and setting EXP rewrite with QoS flow information, activation is
executed by the activation designation defined by QoS flow information.
1-8
List of Interfaces that Support Flow Control
flow filter
Input Output
Side Side
---
--- (1*)
IPv4
flow qos
Input Output
Side Side
--- --- ---
--- ---
(2*) ---(1*) (2*)
IPv6
flow filter flow qos
Input Output Input
Side Side Side
--- --- ---
---
--- (1*) (2*) ---(1*)
GR2K-GA-0014
Output
Side
---
---
(2*)
Ver. 07-02