Hitachi GR2000 Series Configuration Commands page 493

Table 5-25 Other Error Messages (continued)
CAUTION: Current configuration file was
successfully changed. Configuration file do
not modified to standby RM because
configuration file copy failed.
CAUTION: Current configuration file was
successfully saved. Update configuration file
do not copy to standby RM because standby
RM is not ready.
CAUTION: Current configuration file was
successfully saved. Update configuration file
do not modified to standby RM because
configuration file copy failed.
CAUTION: Current configuration file was
successfully saved. Update configuration file
do not modified to standby RM because
configuration file is opened in standby RM.
CAUTION: Current configuration file was
successfully saved. Update Configuration file
do not modified to stand by RM because
stand by RM is not ready.
CAUTION: Current configuration file was
successfully saved.Update configuration file
do not modified to standby RM because
cached configuration file create failed.
CAUTION: Current configuration file was
successfully changed. Configuration file was
not modified to standby RM because
configuration file is opened in standby RM.
Command incomplete because processing
configuration deletion exceeded time limit.
To complete deletion, please try same
command again.
Configuration file can not open.
GR2K-GA-0014
Ver. 07-02
Current configuration file was copied, but because it cannot be
copied to standby configuration file, standby configuration
information is not reflected. When updating standby configuration
file, reflect by using config copy command after eliminating causes of
error.
1. Confirm the MC card's mounting status and the remaining
capacity in the standby system using the show mc command (*1).
2. Confirm the RM's CPU use rate using the show "rm cpu"
command (*2).
3. Confirm that the standby system RM board has been inserted
into this device correctly.
Current configuration file was saved, but because standby RM is not
ready, standby configuration information is not reflected.
When updating standby configuration information, start up the
standby, and then reflect by using config copy command.
Current configuration file was saved, but because it cannot be copied
to standby configuration file, standby configuration information is not
reflected. When updating standby configuration file, reflect by using
config copy command after eliminating causes of error.
1. Confirm the MC card's mounting status and the remaining
capacity in the standby system using the show mc command (*1).
2. Confirm the RM's CPU use rate using the show "rm cpu"
command (*2).
3. Confirm that the standby system RM board has been inserted
into this device correctly.
Current configuration file was saved, but because standby
configuration information is opened, standby configuration
information is not reflected. When updating configuration information,
close standby configuration, and then reflect by using config copy
command.
Current configuration information file was copied, but because
standby configuration file cannot be modified, standby configuration
information is not reflected.
When updating standby configuration file, reflect by using config
copy command after eliminating causes of error.
1. Confirm the MC card's mounting status and the remaining
capacity in the standby system using the show mc command (*1).
2. Confirm the RM's CPU use rate using the show "rm cpu"
command (*2).
3. Confirm that the standby system RM board has been inserted
into this device correctly.
Current configuration file was saved, but because standby
configuration information cannot be copied to cached configuration
file, standby configuration information is not reflected. When
updating configuration information, confirm the rest memory size of
MC card by using show mc command, and then reflect by using
config copy command after eliminating causes of error.
Current configuration file was copied, but because standby
configuration information is opened, standby configuration
information is not reflected. When updating standby configuration
file, close standby configuration, and then reflect by using config
copy command.
Because processing deletion of configuration is taking too much
time, command is interrupted. Execute same command again.
Configuration file cannot open. Confirm setting status and the rest
memory size of MC card by using show mc command.
Configuration Error Messages
5-103