Address Translation Information; Table 5-18 Address Translaion Information Error Messages - Hitachi GR2000 Series Configuration Commands

5.18

Address Translation Information

Table 5-18 Address Translaion Information Error Messages

Message
nat:timeout is not in range 300 to 86400
nat:network mask length of NAT source IP
address is not in range 8 to 32.
at:network mask length of NAT translation IP
address is not in range 8 to 30 or 32.
nat:port is not in range 1 to 65535.
nat:port_range is not in range 1 to 65535.
nat:Invalid NAT source IP address.
nat:Invalid NAT translation IP address.
nat:Invalid network mask length of NAT
source IP address.
nat:Invalid network mask length of NAT
translation IP address.
nat:Invalid protocol.
nat:Invalid port.
nat:Invalid port_range.
nat:Invalid service.
nat:incorrect port_range parameters
nat:Maximum number of outside_interface are
already defined.
nat:Maximum number of NAT rule are already
defined.
nat:illegal option -- protocol
nat:illegal option -- port
nat:illegal option -- port_range
nat:illegal option -- service
nat:No such name <name>.
nat:Invalid name <name>.
nat:option requires an argument -- port
GR2K-GA-0014
Ver. 07-02
Contents
The timeout value entered exceeds the prescribed range.
Set it within the range of 300 - 86400.
The post-conversion IP address mask length entered exceeds the
prescribed range.
Set it within the range of 8 - 32.
The post-conversion IP address mask length entered exceeds the
prescribed range.
Set it within the range of 8 - 30 or 32.
The port value entered exceeds the prescribed range.
Set it within the range of 1 - 65535.
The port_range value entered exceeds the prescribed range.
Set it within the range of 1 - 65535.
The pre-translation IP address value entered is invalid.
Set the IP address correctly.
The post-translation IP address value entered is invalid.
Set the IP address correctly.
The pre-translation IP address mask length entered is invalid.
Set mask length correctly.
The post-translation IP address mask length entered is invalid.
Set mask length correctly.
The protocol value entered is invalid.
Set protocol correctly.
The port value entered is invalid.
Set port correctly.
The port_range value entered is invalid.
Set port_range correctly.
The service value entered is invalid.
Set service correctly.
The port number set behind the port_range range designation is
smaller than the port number specified in front.
Set port_range correctly.
Entries exceeding the maximum entry count of outside_interface are
being added.
Delete unnecessary entries before adding new entries.
Inbound NAT entries or outbound NAT entries exceeding the
maximum entry count are being added to NAT rules.
Delete unnecessary entries before adding new entries.
"protocol" is an invalid option with the specified NAT type.
Set the correct NAT type.
"port" is an invalid option with the specified NAT type.
Set the correct NAT type.
"port_range" is an invalid option with the specified NAT type.
Set the correct NAT type.
"service" is an invalid option with the specified NAT type.
Set the correct NAT type.
The specified interface name does not exist.
Set the correct interface name.
The specified interface name is not valid as a NAT interface.
Set the correct interface name.
"Port" is an essential option with the specified NAT type.
Set the "port" option.
Configuration Error Messages
5-97