Isdn Information (Japan Only) - Hitachi GR2000 Series Configuration Commands

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Table 4-11 List of Initial Values That Can Be Set Using ARM Information and Initial
Information
Group Name
VC information Active/non-active state switching of VC
4.7.12

ISDN Information (Japan Only)

Note: ISDN settings are only valid in Japan.
*
Software for using the model GR2000-B overseas currently allows the setting of
ISDN functions. However, since hardware specifications do not support ISDN, a
log message indicating an error is displayed if ISDN configuration definitions are
set. In order to avoid this malfunction, do not set ISDN configuration definitions.
Input Format
d e f a u l t
4-48
Values During Initial Installation (continued)
Information Name
Switching of mode in which Inverse ARP of an ATM line is used
or not used
MTU of ATM line
Setting of cell loss priority display bit
Polling interval in VC state monitoring function using F5-OAM
loop-back cell (seconds)
Number of response reception confirmation times during VC
failure recovery in VC state monitoring function using F5-OAM
loop-back cell (times)
Number of non-response confirmation times during VC failure
generation in VC state monitoring function using F5-OAM
loop-back cell (times)
Request transmission interval during VC failure generation/
recovery in VC state monitoring function using F5-OAM
loop-back cell (seconds)
Initial Value
vc_enable (VC
active state)
inverse_arp
(Inverse ARP is
used.)
4470 bytes
0 (CLP=0)
no (The VC state
monitoring
function does not
operate.)
3 times
5 times
1 second
GR2K-GA-0014
Ver. 07-02