Dhcp Client Information; Nat-Pt; Table 5-20 Dhcp Client Information Error Messages; Table 5-21 Nat-Pt Error Messages - Hitachi GR2000 Series Configuration Commands

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
5.20

DHCP Client Information

Table 5-20 DHCP Client Information Error Messages

Message
dhcp-client: maximum number of interfaces
already defined
dhcp-client: interface already used by other
function
dhcp-client: definition of IP address is not
necessary for the interface used by DHCP
client
dhcp-client: interface not found at '<Interface
Name>'
dhcp-client: invalid host-name
dhcp-client: invalid dhcp-client-id-str
dhcp-client: invalid DHCP option
5.21

NAT-PT

Table 5-21 NAT-PT Error Messages

Message
illegal IP address format.
illegal parameter.
Invalid NAT-PT prefix.
Invalid port range.
Natpt not specified.
out of range.
5-100
Contents
Interfaces are being added that exceed the maximum interface
count. Delete unneeded interfaces before adding new ones.
The specified interface is already in use by a function other than
DHCP client.
An IP address definition is not required for the interface used by the
DHCP client.
The specified interface does not exist.
Set the correct interface name.
This is an invalid host name. Specify the correct host name.
This is an invalid client ID. Specify the correct client ID.
This is an invalid DHCP option. Specify the correct DHCP option.
Contents
The IP address entry format is invalid.
The parameter is invalid.
The NAT prefix is invalid. The following are possible reasons.
1. Host address is not 0.
The length of the network prefix is 96 bits. Set the host address so that it is
0.
2. A link-local prefix has been set.
It is not possible to set link-local prefixes. Set a different network prefix.
The post-translation port number range set by dynamic NAPT-PT translation
rules is invalid. Set the first port number so that it is smaller than the last port
number.
The NAT-PT prefix is not set. Set a NAT-PT prefix first when setting NAT-PT
information.
The specified parameter exceeds the range. Set the value within the range.
GR2K-GA-0014
Ver. 07-02