Hitachi GR2000 Series Configuration Commands page 468

Hitachi gigabit router configuration guide
Hide thumbs Also See for GR2000 Series:
Table of Contents

Advertisement

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Table 5-9
Filter list not specified.
Filter list number not specified.
Filter not specified.
Invalid ip destination network class.
Invalid ip source network class.
Invalid name <name>.
Invalid phb scheduling class.
Invalid policy routing group name.
Invalid policy routing interface name.
Invalid QoS discard mode NIF no.
Invalid QoS interface name.
invalid Rate4
IP destination high is less than IP destination
low.
IP source high is less than IP source low.
length out of range
Maximum number of filter group
configurations area already defined.
Maximum number of filter list configurations
are already defined.
Maximum number of QoS bridge
configurations are already defined on the RP.
Maximum number of QoS bridge
configurations are already defined.
Maximum number of QoS hdlc passthrough
configurations are already defined on the RP.
Maximum number of QoS hdlc passthrough
configurations are already defined.
Maximum number of QoS interface
configurations are already defined on the RP.
Maximum number of QoS IP configurations
are already defined on the RP.
Maximum number of QoS IP list
configurations are already defined.
5-78
Filter and QoS Information (Other than Flow Information) Error Messages
IP filter list has not been specified. Specify an IP filter list.
IP filter list entry number has not been specified. Specify the entry
number.
IP filter has not been specified. Specify the IP filter.
Invalid ip destination network class and sub-network class. Specify ip
destination network class and sub-network class.
Invalid ip source network class and sub-network class. Specify ip
source network class and sub-network class.
Entered name of configuration information invalid.
For interface: Specify interface except for AUX name on IP defined.
For Qos IP, Qos IPX, Qos bridge, QoS HDLC: Specify interface
except for rmEthernet and AUX name on IP defined
For QoS interface: Specify name set in ethernet, frame relay, dlci,
ppp and isdn ppp.
A name of <name> configuration information.
Invalid band configuration value. Specify band configuration value
when band configuration type is cs or af.
Invalid policy routing group name. Specify policy routing group name.
Invalid policy routing interface name. Specify policy routing interface
name in except for AUX.
This is NIF number of ATM. Specify NIF number of NIF other than
the already set ATM.
ATM line, timeslot or line where Frame-Relay protocol operates is
specified. Specify an interface name of an interface except an ATM
line, timeslot or line where Frame Relay protocol operates is
specified.
The maximum send bandwidth of queue #4 is invalid.
Destination IP address (high) is less than destination IP address
(low). Specify a destination IP address (high) greater than the
destination IP address (low).
Source IP address (high) is less than source IP address (low).
Specify a source IP address (high) greater than source IP address
(low).
The input value exceeds the prescribed range. Set the queue length
within the range of 0 - 4000.
Number of the IP filter group entries exceeded 256. Decrease the
entries to 256 or fewer.
No more IP filter list configurations can be defined. Decrease the list
configurations to no more than the total of 1024 entries including the
QoS IP list configurations.
Maximum number of QoS bridge configurations are already defined
on the RP. Set to 32 or less configuration per RP.
Maximum number of QoS bridge configurations are already defined.
Set to 5 or less information per RP.
Maximum number of QoS hdlc passthrough configurations are
already defined on the RP. Set to 32 or less information per RP..
Maximum number of QoS hdlc passthrough configurations are
already defined. Set to 5 or less information per RP.
Maximum number of Qos interface configurations already defined on
RP. The limit is 480 entries per RP.
Number of QoS IP configurations exceeded maximum value.
Decrease number to 512 per RP.
No more QoS IP list configurations can be defined. Decrease list
configurations to no more than a total of 1024 entries including IP
filter list configurations.
GR2K-GA-0014
Ver. 07-02

Advertisement

Table of Contents
loading

Table of Contents