Hitachi GR2000 Series Configuration Commands page 310

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
To delete an SNMP Manager:
To display registered SNMP Managers:
Parameters
<
Description:
Default:
Range of value:
Description:
Default:
Range of value:
{
Description:
Default:
Range of value:
Description:
Default:
Range of value:
Description:
Default:
Range of value:
3-2
Specifies the SNMP Manager community name.
Undefined (but cannot be omitted).
Same as
GR2000 Configuration Commands, (universal CLI) Vol. 1.
Specifies the SNMP Manager IP address.
Undefined (but cannot be omitted)
Specify IP address (dot notation) in <SNMP manager IP
address> or specify IPv6 address (colon notation) in <SNMP
manager IPv6 address>.
Sets the MIB operation mode for the specified SNMP Manager.
When -read is specified, Get Request and GetNext Request are
permitted. When -read_write is specified, Get Request, GetNext
Request, and Set Request are permitted.
read
read or read-write
Sets the trap transmission mode for the specified SNMP
Manager. When none is specified, no trap is performed. When
trap is specified, the standard trap is enabled. When ex_trap is
specified, both the standard trap and the private trap are
enabled. The individually specified trap is issued when
selection_trap is specified.
none
Select none, trap, ex-trap or selection_trap
Sets the transmission level of the system messages for the
private trap. This parameter is valid only when the trap
transmission mode is ex_trap or system_msg_trap. Table 3-2
displays the list of system messages to transmitted by the
private trap depending on the level specified by this parameter.
9
1 to 9 (decimal) is specified in <Level>.
. See Table 2-1, in
GR2K-GA-0014
Ver. 07-02