Qos; Figure 1-8 Range Of Tos-Qos Conversion Table Information Control - Hitachi GR2000 Series Configuration Commands

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Flow Control (input)
Priority Determination
TOS Rewrite
Contracted Bandwidth
Monitoring
: Control range of this command

Figure 1-8 Range of TOS-QoS Conversion Table Information Control

6. Non-IP protocol QoS control
Non-IP protocol (IPX, Bridge, HDLC, etc.) QoS control is set using three
commands: IPX QoS (qos-ipx), bridge QoS (qos-bridge), and HDLC QoS (qos-hdlc).
These define QoS control for IPX, Bridge, and HDLC protocols, respectively.
1.2.1

qos

This command sets the use and disuse of flow control. The setting of use and disuse
is enabled when the flow control is set using the old, BSD UNIX-based command
system (qos-ip-hst, quos-ip-hst-group, or qos-ip). The setting of use and disuse in this
command is disabled when the flow control is set using a flow command. Set the use
and disuse using a flow command when setting the flow control using a flow
command.
Input Format
Setting information
Modifying information
Deleting information
Displaying information
Parameters
Description:
1-134
1.2.7 qos-tos-map
Sets from qos-tos-map.
Flow Control (output)
1.2.9 qos-ipx
1.2.10 qos-bridge
1.2.11 qos-hdlc
enable/disable flow control
: disable
-no
Queue Control
Priority Determination
TOS Rewrite
Contracted Bandwidth
Monitoring
Transmission Control
Interface
(LINE,DLCI, etc.)
GR2K-GA-0014
Ver. 07-02