Nat-Pt Information; Table 4-15 List Of Default Values That Can Be Set Using Nat-Pt Information And Default Values During Initial Installation - Hitachi GR2000 Series Configuration Commands

4.7.15

NAT-PT Information

Input Format
Changing information:
Parameters
The default value items that can be set using NAT-PT Information and the default
values during initial installation are shown in Table 4-15. For details of each
parameter, refer to the configuration definition information in GR2000 Configuration
Commands, (universal CLI) Vol. 1.
Table 4-15 List of Default Values That Can Be Set Using NAT-PT Information and
Information
Group Name
IP interface
information
GR2K-GA-0014
Ver. 07-02
Default Values During Initial Installation
Information Name
ARP cache table aging time
Interface type (Valid only for ATM/
Frame-Relay.)
Proxy ARP response
Encapsulation format of ARP request
frame (Hardware type)
Maximum number of transmission retries
in ARP request frame
Transmission retry interval of ARP request
frame
Relay of IP packets with source route
option
Direct broadcast relay switch
Subnet broadcast relay switch
Non-response option of ICMPv6 node
information query
rate limiting option (RFC2463)
Operation Management Information
Initial Value
30 minutes
Broad-type
No proxy ARP response is made.
ethernet
4 times
2 seconds
IP packets with a source router option are
relayed.
Not relayed.
Not relayed.
• The initial value responds.
ip_icmp6_nodeinfo_query
• To set a non-response option, execute
the following.
ip_icmp6_nodeinfo_query_off
• The transmission rate of an ICMPv6
error is limited to 1 packet/
<Microsecond> (maximum).
• The initial value is enabled(500 s).
• To disable this function, set the
<Microsecond> value to "0".
• The <Microsecond> value can be set
up to 1000 in units of 0 to 10.
4-53