Hitachi GR2000 Series Configuration Commands page 312

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Setting is made for the purpose of selecting MIBs appended at the time when link
up/down traps are issued.
MIBs appended at the time of link up/down trap issuance by the setting of this
parameter are indicated in the table below.
Parameter
Interface
Protocol
Default:
Range of value:
Description:
Default:
Range of value:
This parameter transmits the trap in case that a BGP link is established and
This parameter transmits the trap in case the upward threshold value of an rmon
alarm is exceeded and the downward threshold value is not exceeded when the
Trap transmission mode is selection_trap.
This parameter transmits the trap in case the state of E1 and T1 interfaces
change when the trap transmission mode is selection_trap.
This parameter transmits the trap in case the state of T3, E3, CE3, and CT3
interfaces change when the trap transmission mode is selection_trap.
This parameter transmits the trap in case the state of vrrp changes when the
Trap transmission mode is selection_trap.
This parameter transmits the trap in case a system message is output when the
Trap transmission mode is selection_trap.
This parameter transmits the trap in case standby RM is put into the UP/DOWN
state when the Trap transmission mode is selection_trap.
3-4
Moment at Which link up/down trap is Issued
• (SNMPv1/SNMPv2 trap common) ifIndex, ifDescr, ifType
• (In case of SNMPv1 trap) ifIndex,
• (In case of SNMPv2 trap) ifIndex, ifAdminStatus, ifOperStatus
standard
private or standard is specified.
Sets the trap transmission version to the manager of the
specified IP address that belongs to the specified community
name. The trap of an SNMPv1 version is issued when "1" is
specified. The trap of an SNMPv2 version is issued when "2" is
specified.
1
Specifies "1" or "2".
disconnected when the Trap transmission mode is
selection_trap.
GR2K-GA-0014
Ver. 07-02