Table 1-59 Corresponding Values - Diff-Serv - Hitachi GR2000 Series Configuration Commands

Table 1-59 Corresponding Values - Diff-serv

7 6
2 2
DSCP
The six high-order bits are specified.
DSCP = Differentiated Services Code Point
CU = Currently Unused
Default:
Range of value:
Description:
Default:
Description:
Default:
Range of value:
GR2K-GA-0014
Ver. 07-02
5 4 3
2 2 2
None (Does not include TOS value to the condition of flow
detection.)
0-255
Specifies the method of checking the transmission source IP
address and the destination IP address. The
checks for both switching as well as non-switching source IP
address with destination IP address (see Note later in this
subsection). The
switching source IP address with destination IP address. The
option requires setting of the synchronized pair
-ip_pair
switch for the IP address upper protocol port number to off
(
-pair_synchronized_off
On
Specifies the source IP address. When both source and
destination IP addresses are set under one condition, set so
that the specified addresses do not overlap. If they overlap, set
an IP address pair switch as ip-pair_off. (Note 1)
When specifying only one IP address:
When specifying addresses within a range:
Specify the lower limit and upper limit of IP addresses:
Specify the subnet mask:
Specify the subnet mask length:
or
You cannot directly modify the subnet mask or the subnet
mask length for only one IP address. You must first delete the
setting by entering
and then specify the IP address.
-ip_source
Undefined
IP address: 0.0.0.0–255.255.255.255
Subnet mask: 255.0.0.0–255.255.255.255
Subnet mask bit length: 8–32
2 1 0
2 2 2
CU
option only checks for not
-ip_pair_off
).
delete filter-list <Filter List No.>
Filtering/QoS Information
option
-ip_pair
-ip_source <IP Address>
1-113